Swiftech H20 80 - Manual (Page 23)

Parts list
Parts QTY PARTS QTY
MCW6000-PX™ water-block 1 6-32 x 1 ¼” Philips screws 4
Worm drive clamps 2 Springs 4
SP4 hold-down plate 1 Standoffs 4
4-40 Nylon retaining washers 4 Black fiber washers 8
Locknuts 4
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to
your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit our web site at
www.swiftnets.com for updates.
The MCW6000-PX can be installed using two different methods:
Using the spring-loaded screws and standoffs included with the water-block (fig. 1 below)
Using the plastic retention frames and spring clips included with most motherboards (fig. 2 page 2)
Assembly using our
spring-loaded screws
and standoffs
ITEM NO. PART NO. DESCRIPTION
1 DUAL-XEON-BOARD Motherboard
2 STANDOFF swtainless steel hexagonal 1/4" standoff
3 6-32-LOCKNUT 6-32 LOCKNUT
4 FW140X250X0215FB BLK black fiber washer
5 MCW6000-P-with-bracket MCW6000-P water-block assembly
a MCW6000-FLAT MCW6000 waterblock flat base
b SP4-Bckt SP4 Holding plate for Intel Pentium 4 and Xeon
6 91772A154-phil6x32x1.125 6-32 x 1 1/4" philips scfrew
7 70750 0.042 diam Heavy Duty spring
8 4-40 nylon retaining washer 4-40 nylon retaining washer
6
7
8
2
4 3
1
FLUID INLET
FLUID DISCHARGE
Figure 1
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content
Copyright Swiftech 2004 – Last edited 9-11-04 – Subject to revision without notice - 23 of 38 -