Swiftech H20 80 MICRO User Manual
Page 16
Copyright Swiftech 2005 – All rights reserved – Last revision date: 06-14-06- Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 16 of 20
The Apogee water-block ships pre-installed with the multi-socket hold-down plate. In order to install your Apogee with AMD’s AM2 socket, you will
need to remove the existing hold-down plate and replace it with the AM2 model as follows:
Step 1: loosen all 4 screws using the included hex key, and set aside
the standard hold-down plate.
Step 2: place the AM2 hold-down plate on the Apogee body, and
fasten all four screws in cross pattern.
You can now use your Apogee with AM2 socket. Please read the common and step by step installation guidelines in page 2 to proceed with the
installation of the product.