Step 7. rest the assembly back on top of the comp – Swiftech MCRES 1000P User Manual
Page 2
TIP!
If you overfill the reservoir, you can use a bundled-up
paper towel to soak-up the excess fluid.
Step 4. Tilt the assembly upwards to allow the fluid to fill-up the
circuit by simple gravity. Allow the fluid to fill-up both tubes. The
pump discharge line will retain a 2” long bubble, which is
normal at this stage. See troubleshooting
if the pump
discharge tube does not fill-up properly.
Step 5. Rest the assembly back on top of the computer, and
complete filling-up the reservoir until the fluid reaches the
. Close the fill port with the provided fill-cap. Do
not over tighten the fill-cap. The fill-cap is equipped with an o-
ring and does not require excessive pressure to seal properly.
Step 6. Rest the assembly on its side, down on your workbench
and connect the pump Molex connector to the power supply. You
must be able to start the PSU without it being connected to the
motherboard (
). Start-up the PSU. The pump has a 3
Seconds delay before it start running. Observe the flow circulating
throughout the circuit, until all the bubbles disappear. DO NOT
OPERATE THE PUMP IF THERE IS NO CIRCULATION, and
refer to troubleshooting
before proceeding any further.
A
LLOW THE SYSTEM TO RUN FOR
(3)
HOURS
,
AND FREQUENTLY INSPECT ALL YOUR CONNECTIONS FOR POSSIBLE LEAKS
.
Step 7. Rest the assembly back on top of the computer, and
complete filling-up the reservoir as necessary. You may slightly
angle (approx. 15°) the reservoir to top-off the fluid level, by
placing a small object under the reservoir. Then close the fill port
with the provided fill-cap. Your reservoir is now ready to use.
Step 8. Install the assembly in the desired CR Rom bay, and
secure with the provided standard M3 screws. The MCRES-
1000P is designed to be recessed from the front panel, and allow
clearance for various cover plates or fan controllers.
Step 9. Connect the pump’s 4 pin Molex connector to the computer PSU, and the 3-pin connector (RPM sensor) to the CPU fan
header on the motherboard. INSTALLATION IS NOW COMPLETE!
Copyright Swiftech 2005 – All rights reserved – Last revision date: 4-16-05 - Information subject to change without notice – URL: http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected] PAGE
2 of 4