Spektrum DX6 - Manual (Page 42)

42 SPEKTRUM DX6 • TRANSMITTER INSTRUCTION MANUAL
EN
 
 
 
 
Adjusting the Throttle Ratchet Strap
The user can loosen the friction strap screw and tighten the
ratchet screw if desired by pulling the top of the grip through the
throttle adjustment opening.
No installation required, no need to remove the case back.
You can adjust the Throttle Ratchet Strap to use either a smooth
throttle or ratchet throttle.
To adjust the Throttle Ratchet Strap:
1. Remove the rubber plugs from the holes on the back of the
transmitter.
2. Using a #0 Phillips screwdriver, loosen or tighten the Throttle
Ratchet Strap screw to adjust the ratchet to your liking.
3. Re-install the plug.
Control Stick Length Adjustment
To adjust the Control Stick Length:
1. Using a 2mm Allen wrench, turn the setscrew in the stick
counterclockwise to loosen it.
2. Make the stick shorter by turning it clockwise or longer
by turn ing it counterclockwise.
3. After adjustment of stick length, tighten the setscrew.
Adjust Stick Tension
Adjust stick tension using the screws on the stick gimbals through
holes in the back of the transmitter.
1. Pull up the top of the rear grip on the back of the transmitter
to adjust the stick gimbal tension. Only the top of the grip
must be pulled up to access the adjustment screw. The entire
grip does not need to be removed.
2. Turn the screws in these holes marked with a vertical or
horizontal arrow a small amount using a small Phillips
screwdriver.
NOTICE: Always do a test of stick tension while turning these
screws to ensure stick tension is not too loose or too tight.
Tightening a screw too much can damage a spring. Loosening a
screw too much can let a spring fall off and cause short-circuit in
the transmitter.
CAUTION: Always power off the transmitter, disconnect and
remove the battery before adjusting stick tension or friction
straps. Not doing so could result in property damage or injury.
Adjust Throttle Friction Straps
To adjust Throttle Friction:
1. Remove rubber plugs from holes on the back of the
transmitter.
2. Use a small Phillips screwdriver to tighten or loosen the
screw for the friction strip.
3. Reinstall the plug after completing the adjustment as desired.
CAUTION: Always power off the transmitter, disconnect
and remove the battery before adjusting stick tension or
friction straps. Not doing so could result in property damage or injury.
Function
1
Gimbal spring access
2 Throttle friction strip tension cover
3 Mode change access
1
1
2
3
PHYSICAL TRANSMITTER ADjUSTMENTS