Spektrum SPMR9900 DX9 - Manual (Page 23)

23 SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL
EN
Serial Number
The Serial Number screen displays the transmitter serial number
and AirWare software version.
Reference the Serial Number screen any time you need to
register your transmitter or update the AirWare software from the
Spektrum Community website.
Exporting the Serial Number to the SD Card
You may find it helpful to export the transmitter serial number to a
text file for your personal records or when you are registering the
transmitter on the Spektrum Community.
To export the transmitter serial number:
1. Insert an SD Card in the card slot on the transmitter.
2. Scroll to
EXPORT and press the scroll wheel. The SD Status
screen appears and should display MY_DX9.xml in the middle
of the screen.
3. Press the scroll wheel again to return to the Serial Number
screen.
4. Power off the transmitter and remove the SD Card from the
transmitter.
5. Install the SD Card in a card reader connected to your
computer.
6. Open the MY_DX9.xml file from the SD Card location. You
can then copy and paste the serial number into your personal
records or to the Spektrum Community website.
Locating the Transmitter AirWare Software Version
The transmitter AirWare software version appears between PREV
and NEXT at the bottom of the Serial Number screen. Register
your DX9 to get AirWare software updates and other news at
spektrumrc.com
IMPORTANT: AirWare files are specific to the transmitter
serial number and you cannot transfer AirWare files between
transmitters, ie., downloading an AirWare software update once
and attempting to install it on multiple transmitters.
Calibrate
The Calibration screen stores the potentiometer endpoints for all
proportional controls. It is mandatory to complete the calibration
after changing the stick mode selection.
Calibrating the Transmitter
1. Carefully move the gimbal sticks in a + shape moving from
left to right, then up and down. Press gently on the gimbals
at the stops to achieve an accurate calibration. Return both
gimbal sticks to the center position.
2. Move the Left and Right Side Levers to the top and bottom
positions, then move the side levers to the center position.
IMPORTANT: Only move one side lever at a time during
calibration.
3. Move the Knob to the full clockwise and counterclockwise
positions, then return the Knob to the center position.
4. Select SAVE to store the calibration.