System setup, Monitor – Spektrum SPMR9900 DX9 User Manual
Page 31
31
SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL
EN
Custom Voice Setup
Use the custom voice setup function to set up custom voice alerts
or messages. For example, with the custom voice setup function
you can be alerted to a switch change report or a sequence of
alerts using the Stepping Events option. To add a new custom
voice alert or command, enter the Custom Voice Setup function
and select Add New Sound Event with the roller. Select either
Switch Change Report or Stepping Events.
Switch Change Report
Use this feature to have telemetry read in a certain switch
position, current switch position, or a variety of other alerts such
as “Landing Flaps” or “Mix On”. Begin by selecting the switch you
wish to use for the spoken alert, then select the desired setting
next to each switch position.
Stepping Events
Stepping Events can be used to provide voice alerts when a
switch is moved stepping through a list of events. Begin by
selecting the switch desired to trigger each step through the list
(when the switch is triggered as selected, the system will move
to the next item on the list going through the list of user-defined
selections one by one.) Auto-Cycle can be selected to Inhibit or
Active. If inhibited, the system will go through the list 1 time only,
if the switch is triggered again when at the final item in the list, it
will not begin at the top of the list. If Active, the system will restart
at the beginning of the list after the last item on the list with the
next switch trigger. Steps is used to select the number of items
on the list for the system to call. This can be set from 0 to 16.
So there can be up to 16 items called to the pilot triggered by
the switch selected. Next select the alert to be spoken for each
stepped event on the list as desired. A variety of alerts can be
chosen from the list including telemetry alerts and a variety of
flight conditions and commands.
System Setup
Press here to enter the System List from the Function list without
turning the transmitter off. A Caution screen will appear that warns
that RF will be disabled (the transmitter will no longer transmit).
Press
YES if you are sure and want to access the System List. If
you are not sure, press
NO to exit to the main screen and continue
operation.
If you do not press
YES or NO, the system will exit to the main
screen and continue operation within approximately 10 seconds.
WARNING: Do not press YES unless the model is turned
off or the model is secured.
Monitor
The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions, trim settings, mix directions, etc. The numeric value is
directly relative to the travel adjust and mix values (e.g., 100%
travel adjust equals 100% value in the Monitor).