Spektrum SPMMSJR9 - Manual (Page 17)

Spektrum Air Module 1
It’s necessary to program the receiver to the specific module so that the receiver
will only recognize that module, ignoring signals from any other sources. If the
receiver is not bound to the module, the system will not operate. During binding
the servo’s fail-safe positions are stored.
The following sequence shows the binding procedure for the AR7000, however, all
Spektrum aircraft receivers are bound in the same way.
How to Bind
The AR7000 receiver must be bound to the module before it will operate.
Binding is the process of teaching the receiver the specific code of the transmitter
so it will connect to that specific module. Once bound, the receiver will only
connect to that module.
1. With the system hooked up as shown, insert the bind plug in the
charge plug receptacle.
Binding