Airlink AP431W - Manual (Page 14)

Section 6
Connecting to the Access Point
Once you have properly configured the Access Point, your wireless computers should be able to detect
its signal.
Use your wireless network adapter’s utility to detect and connect to the Access Point. You can identify the
Access Point by its MAC Address, which is displayed in the BSSID field of your wireless network
adapter’s utility.
You can check the Access Point’s MAC Address on its bottom label.
If the signal is weak, try reorienting the Access Point’s antenna or relocate the Access Point to a different
place.
For more detailed information about using the Access Point’s Web Configuration Utility, please refer to
the User’s Manual on the provided CD.
Section 7
Technical Support
E-mail: [email protected]
Toll Free: 1-888-746-3238
Web Site: www.airlink101.com
Copyright © 2007 AirLink101. All rights reserved. AirLink101, the stylized AirLink101 logo, specific product designations, and all other words and
logos that are identified as trademarks and/or service marks are, unless noted otherwise, the trademarks and service marks of AirLink101. All other
product or service names are the property of their respective holders. AirLink101 products are protected under numerous U.S. and foreign patents
and pending applications, mask work rights, and copyrights.
* Super G™ technology (108Mbps) can only be obtained when using products with Atheron Super G™ chipset.
* Theoretical maximum wireless signal rate based on Atheros™ Super G™ and IEEE standard 802.11g specifications. Actual data throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, mix of wireless products
used, radio frequency interference (e.g., cordless telephones and microwaves) as well as network overhead lower actual data throughput rate.