Disarming without a transmitter, Silent mode, Panic mode – AstroStart Security System VSS-113 User Manual
Page 7: Valet mode
D
ISARMING WITHOUT A TRANSMITTER
This feature allows you to disarm the security system without the remote transmitter should it be
lost or damaged. In order to disarm the system without a remote transmitter, you must have the
vehicle’s ignition key and know where the Valet button is located. Be sure to check with the
installer for the location and the number of presses of the Valet button required to disarm the
system.
© 2006 A
STROFLEX
E
LECTRONICS
– A
LL RIGHTS RESERVED
5
To disarm the security system, turn the ignition to the ON position.
Press the Valet button the preset number of times (one to five
times) within 15 seconds. After 5 seconds, the system will now
disarm. If the system does not disarm, you may have waited too
long; turn the ignition off and try again.
Location of Valet Button :
Number of Pulses :
Important! The unit can be programmed to respond to one to five pulses of the Valet button
for the disarm function. Be sure to check with the installer for the desired programming.
S
ILENT MODE
To temporarily turn off the arm or disarm chirps, use Silent Mode™. Simply press
for less than
one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that
one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can
do this for you.
Note: The Warn Away
®
response to lighter impacts is bypassed if the system is armed
using Silent Mode. This ensures that no chirps will be emitted by the siren in an area
you want chirp-free.
The system is still fully capable of triggering, only the Warn Away
®
response is bypassed.
P
ANIC MODE
If you are threatened in or near your vehicle, you can attract attention by triggering the system
with your transmitter. Just press
or
for five seconds, and you will enter Panic Mode. The
siren will sound and the parking lights will flash for the programmed siren duration. To stop Panic
Mode at any time, press
or
for one second on the remote transmitter again.
V
ALET MODE
You can prevent your security system from automatically arming and triggering by using Valet
Mode. This is very useful when washing the vehicle or having it serviced. In Valet Mode, the