AstroStart Security System VSS-113 - Manual (Page 8)

security system will not arm, even with the remote transmitter, but all convenience functions
(door locks, trunk release, etc.) will continue to work normally.
To enter or exit Valet ® Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet ® switch within 10 seconds.
To enter or exit Valet Mode using the transmitter:
1. Open any vehicle door.
2. Press .
3. Press or .
4. Press again.
The status LED will light solidly if you are entering Valet Mode, and it will go out if you are exiting
Valet Mode.
N
UISANCE PREVENTION
®
CIRCUITRY
Your system has Nuisance Prevention ® Circuitry (NPC ® ). It prevents annoying repetitive trigger
sequences due to faulty door pin switches or environmental conditions such as thunder,
jackhammers, airport noise, etc.
Example
If the alarm triggers three times within a 60-minute period and each time the same sensor or
switch triggers the alarm, NPC ® will interpret those triggers as false alarms. After the third trigger,
NPC ® ignores, or bypasses, that sensor or switch (along with any other sensors or switches sharing
the same zone) for 60 minutes. If the bypassed sensor tries to trigger the system while it is being
bypassed, the 60-minute bypass period will start over. This ensures that a sensor that continually
triggers will remain bypassed.
© 2006 A STROFLEX E LECTRONICS – A LL RIGHTS RESERVED
6