Nikon LS-1000 - Manual (Page 24)

- 24 -
Remarks
• The maximum number of SCSI devices that can be
connected to one computer is eight. In the case of a host
computer with a built-in SCSI hard disk or built-in CD-ROM,
note that SCSI ID numbers have been pre-assigned for the
host CPU and the SCSI devices.
• The SCSI cable must not be extended beyond a total length
of 19 feet (6 meters), or else failure may result.
• If you use the type of terminator that is inserted between
the SCSI cable and SCSI interface connector, install a
terminator independent of the other SCSI connector of the
LS-1000.
• Terminators must be attached to the devices located at both
ends of the SCSI chain.
If the host computer is a Macintosh, the Macintosh itself will
provide termination at one end of the chain.
If the host computer is an IBM PC/AT or compatible,
equipped with an SCSI board, the SCSI board itself will
present termination at one end of the chain.
Note that when an SCSI chain connection is made inside a
computer, the end of the SCSI device inside the computer
will become the end terminal.
• Before installing an SCSI board, be sure to read the user’s
manual provided with the board. The numbers for the I/O
address, interrupt level (INT) and DMA channel might be
used for other interface boards and peripheral devices. If so,
change them as explained in the manual.