Nikon S3300 - Manual (Page 69)

53
Features That Can Be Set Using the Multi Selector
Sh
ooting Feat
ures
Using the Flash (Flash Modes)
The flash mode can be set to match the shooting conditions.
1
Press the multi selector
H (m flash mode).
2
Press the multi selector
H or I to choose the
desired flash mode and press the
k button.
• See “Available Flash Modes” (A54) for more
information.
• If a setting is not applied by pressing the k button
within a few seconds, the selection will be canceled.
• When U (Auto) is applied, D is only displayed for
a few seconds, regardless of Photo info settings
(
E53).
3
Frame the subject and take a picture.
• The flash lamp indicates flash status when the shutter-
release button is pressed halfway.
- On: The flash will fire when you press the shutter-
release button all the way down.
- Flashes: The flash is charging. Wait a few seconds
and try again.
- Off: The flash will not fire when a picture is taken.
• If the battery is low, the monitor will be turned off while the flash is charging.
C
Effective Range of the Flash
When ISO sensitivity is set to Auto, the flash has a range of 0.5–4.5 m (1 ft 8 in.–14 ft) at the
maximum wide-angle zoom position and a range of 0.5–2.4 m (1 ft 8 in.–7 ft 10 in.) at the maximum
telephoto zoom position.
Auto
7 6 0
2 9 m 0 s