ROTHENBERGER PIPECUT 360 PRO - Manual (Page 15)

15
INSTRUCTIONS FOR USE
Extension cables outside
When you work outdoors, always use an extension cable
that is made and approved for outdoor use.
Be alert
Concentrate on your work. Use common sense. Do not
use the pipe saw when you are tired or drowsy. Never use
the pipe saw under the influence of alcohol or drugs.
Use the right tool
Never use a low-power tool or accessory for work that
requires a high-powered tool. Never use the pipe saw for
purposes for which it is not intended.
Remove the key
Check that the blade key has been removed before
starting the pipe saw.
Accessories
Only use additional accessories and equipment
recommended by the manufacturer. The use of another
manufacturers accessories may cause an accident.
Check for damaged parts
Before using the pipe saw, check that: all of its
components are in good condition, are correctly installed
and that all moving parts operate correctly. Always
check the attachments of the blade guard. Also check
that everything else that can affect operation is in good
condition. Never use the pipe saw if the power switch
does not operate properly or if the cable is damaged. A
damaged part should be repaired or replaced with a new
one at an approved service agency.
Have your machine repaired at an approved service
agency
Your retailer will give you a list of approved service
agencies. For safety reasons, only approved service
agencies may service or change the machine’s electrical
components.
Do not cut pipes containing asbestos
Asbestos is considered to be carcinogenic substance.
Check the blade
Use only correct blades in good condition, which are
suitable for the material to be cut, for the pipe size and
for the speed of the saw
Do not take the pipe saw out in the rain. Never use
it in wet or damp conditions.
Intended use and limitations 5.
The PIPECUT 360 PRO is intended for use as a pipe fitter’s
tool at the installation site.
The PIPECUT 360 PRO can only be used to cut round
pipes, with a diameter of 75 to 360 mm and a maximum
wall thickness of 8mm with steel and 12mm with plastics.
The PIPECUT 360 PRO can be used to cut all normal pipe
materials, such as steel, stainless steel, cast iron, copper,
aluminum, and plastic. PIPECUT 360 PRO pipe saw is
intended for short, intermittent use. The machine may
be loaded for 2.5 minutes during a 10-minute period (S3
25 %). The PIPECUT 360 PRO is not intended for use in
industrial production.
The pipe saw must never be used in the following
cases, if:
• There is water or another liquid, explosive gases or
poisonous chemicals inside the pipe to be cut.
• The power switch is faulty.
• The power cable is faulty,
• The blade is bent.
• The blade is blunt or in poor condition.
• The plastic components are cracked or have parts
missing.
• The gripper unit is not properly tightened around
the pipe or if it is warped.
• The blade guard cover or moving blade guard has
been damaged or removed from the machine.
• The locking mechanisms do not work properly
(UNLOCK-button).
• The pipe saw has become wet.
When using the pipe saw, the following factors must
always be taken into consideration:
• Ensure that the pipe to be cut is empty.
• Ensure that the blade is correctly installed.
• Ensure that the diameter and thickness of the blade
are suitable for the pipe saw and that the blade is
suitable for the rpm-range of the machine.
• Never use sideways force to stop the blade, always
allow the blade to stop freely.
• Check the attachments of the blade guards.
• Never use excessive force when using the pipe saw.
• Never use the pipe saw to lift the pipe while it is still
attached to the pipe.
• Avoid overloading the electric motor.
• Always follow the safety and operating instructions and
current regulations.