ROTHENBERGER PIPECUT 360 PRO - Manual (Page 16)

16
Before operating the tool
• Ensure that the motor unit is in the upright position.
The yellow mark of the UNLOCK button is visible.
• Check that the blade is correctly fitted, in good
condition and suitable for the material to be cut.
• Ensure the pipe saw guide wheels rotate.
• Ensure the support wheels rotate.
• Check the operation of the lower blade guard.
• Ensure the pipe is empty.
• It plastic pipes have been cut with the pipe saw
(resulting in long, statically charger slivers), open
the blade guard cover, and clean carefully the lower
blade guard and the entire pipe saw.
Connection to the mains power supply
Ensure that the mains voltage is the same as indicated on
the rating plate (Figure A/14). Connect the pipe saw to
the power outlet only after having checked this.
Precise setting of the cutting point
When you mark the cutting point on the pipe to be cut,
deduct 20 mm from the required dimension (Easy-to-
remember rule: The cutting mark location requires a
measurement of - 20 mm.)(Figure C)
Setting the pipe on supports
Use the system supports when cutting pipes. This will
ensure safe working and optimum result. Work on flat
underground. Lift the pipe onto the cutting holder so that
the sawing point is between the holders’ wheel pairs.
Make sure that the wheels on all the holders are in
contact with the pipe (adjust if required e.g. with pieces
of lumber) (figure B).
When cutting short pipes (25cm or less) place the
supports so that the cutting point is outside supports
(figure D). Support the pipe with your left leg, if required.
Proper arrangements will prevent the blade from jamming
as the pipe is cut through.
Unlock Locked button
INSTRUCTIONS FOR USE
Operating instructions 6.
Fig. B
Fig. G
Fig. C
Fig. D
Fig. E