Vertical contact toaster, Troubleshooting (continued) – A.J. Antunes & Co VCT-2000 9210214 User Manual
Page 18
VERTICAL CONTACT TOASTER
18
P/N 1010874 Rev. I 04/14
Problem
Possible Cause
Corrective Action
Toaster makes
unusual sounds.
Compression Settings are too tight.
Set Compression Settings to the correct (or larger)
setting.
Conveyor Belt Wrap is installed
incorrectly.
Belt Wraps must be installed as described in the
Maintenance section of this manual.
Belt Wrap Pin rubbing on housing.
Center the Pin in the Belt Wrap zipper.
Roller Tensioner(s) bent or missing.
Measure, adjust, or replace the Roller Tensioner(s)
as described in the Maintenance section of this
manual.
Conveyor Belt Chains have
stretched.
Measure and adjust the conveyor Belt Chains as
described in the Maintenance section of this
manual.
Conveyor Belt Chains adjusted
incorrectly.
Sugar and/or carbon has accumu-
lated inside the Conveyor Belt Wrap
and between the Conveyor Belt
chain and Tensioner Slide Rails.
Remove Belt Wraps and clean conveyor Belt Chain
links just as you clean the Belt Wraps daily. Then
clean the Slide Rails on the Tensioners. Next, clean
the Belt Wrap on both sides before reinstalling it.
Motor Drive Chain needs lubrication. Lubricate the Drive Chain carefully with Lubit-8 (P/N
2140152) at least once a year.
A Conveyor Shaft bearing is binding. Contact your maintenance person or Authorized
Service Agency for service.
TROUBLESHOOTING (continued)