Axis Communications 2401 - Manual (Page 7)

AXIS 2400/2401 Admin Manual Product Description 7
AXIS 2401 Front Panel
DIP Switch
A single line termination for the
supported video output. Units are
shipped with the line termination
enabled; that is, with the DIP
switch set in the down-position.
If the AXIS 2401 is to be con-
nected in parallel with other
equipment, disable the input ter-
mination by turning the corre-
sponding DIP switch to the
up-position (OFF). Failure to do so
can cause the picture quality to
be impaired.
Serial Number
Located on the underside label of the AXIS
2401, the serial number is identical to the
Ethernet address of the unit.
Status Indicator
The multi-colored status indicator
defines the operational status of the
server, as described below:
• green - the indicator flashes briefly
and momentarily displays orange
during the start-up and self-test
routines; the indicator then displays
green to indicate a healthy unit sta-
tus.
• red - the indicator will display red
only if a problem with the AXIS
2401 has occurred
• orange - flashes orange when reset-
ting the factory default settings.
Network Indicator
After completion of the startup
and self test routines, the
multi-colored Network Indica-
tor flashes independently, as
follows:
• yellow - indicating network
activity on a 10Mbps
Ethernet network
• green - indicating network
activity on a 100Mbps Fast
Ethernet network
• red - indicating no physical
connection to the network.
Power Indicator
The Power indicator is normally lit while
power is applied. If it is not lit, or it
flashes, there is a problem with the AXIS
2401 external power source.
Control Button
This button is recessed
within the product casing.
Using a suitably pointed
object, press this button to
restore the factory default
settings. For further infor-
mation, refer to Network
Settings, on page 20.
Video Input
Coaxial BNC connector support-
ing a single video source. The
physical connection is made using
RG59, 75 Ohm coax video cable;
with a recommended maximum
length of 800 feet (250 meters).
Video Output
A single video
loopthrough (VIDEO
OUT) connected in
parallel with VIDEO IN
and terminated with a
coax/BNC connector.
Allows direct connec-
tion of an external
monitor. Set dipswitch
to OFF when in use.