ACR Electronics PLB-350C - Manual (Page 19)

Y1-03-0244B 19
Figure 5 - Belt Clip
APPENDIX A - ACCESSORIES
1. Multi-Function Belt Clip
The SARLink™ View comes standard with a multi-
function belt clip. To install the clip, simply align the
bottom tabs on the clip with the insert holes located on
the bottom of the beacon. Snap the clip in place by
pressing the top of the clip so that the two top tabs
engage in the two insert holes on the top of the
beacon (see Figure 5). To remove the clip, push up
and back on the top tabs one at a time to disengage
the clip from the beacon.
The belt clip has been designed to accommodate your
extreme adventures.
You can secure your beacon directly to backpack
webbing straps, life jackets or belts to ensure the beacon is close at hand. ACR
recommends that you secure your beacon someplace on your person that is
easily accessible in case of an emergency for rapid activation. Ensure the
beacon is secured firmly and is protected before heading out to avoid damage
or loss.
NOTE: ACR recommends that once you have clipped your beacon
in place that you also anchor the beacon with the lanyard to your life
jacket, backpack, etc. to ensure the unit will not be lost if it should
break out of the clip.