HID EDGE Reader Installation Guide - Manual

Installation Guide English
P/N 82000-902-ENEN Rev B.1
EdgeReader
®
and EdgePlus
®
CAUTION: The product is sensitive to Electrostatic Discharges (ESD). Observe precautions while handling the circuit board
assembly by using proper grounding straps and handling precautions at all
times.
1 Preparation (For Indoor Use Only)
Install electrical box.
For new installations: 4” square electrical box (minimum 1 ½” deep) with a
single-gang plaster ring, or equivalent.
Note: To prevent tampering, conceal plaster ring mounting screws with
plasterboard or use tamper resistant screws.
For surface-mount installations: Wiremold
®
V5744S or BW35,
or equivalent.
Remove metal back plate from unit and mount to electrical box, as shown.
2 Wiring
Ethernet 300 feet (100 m) Category 5 cable ALPHA 9504C / 9405F
Wiegand 500 feet (150 m) 9-conductor, stranded, overall shield, 22 AWG ALPHA 1299C
Input Circuits 500 feet (150 m) 2-conductor, shielded, 22 AWG, 18 AWG ALPHA 1292C / 2421C
Specifications
Output Circuits 500 feet (150 m) 2-conductor, shielded, 22 AWG, 18 AWG ALPHA 1172C / 1897C
RS-232 50 feet (15 m) 9-conductor, stranded, 22 AWG ALPHA 1299C / 58119