3 mount, 4 contact, 5 configure – HID EDGE Reader Installation Guide User Manual
Page 2: 6 test, Mount, Contact, Configure, Test, Battery replacement
3
Mount
Hinge the Edge in place and secure with a screw.
4
Contact
Contact Edge through one of the following methods:
Direct Connect
If Edge will be connected to a network using static IP
addressing or if the Discovery GUI is not installed on the PC,
use this method.
Note: The computer must be running Windows 2000 or XP
and be configured for DHCP.
1. Disconnect the computer from the network and directly
connect Edge to the computer with an Ethernet cable
2. Click Start > Run. Enter ipconfig /renew
3.
Access a web browser and enter 169.254.242.121 into
the Address field
Discovery GUI (for DHCP networks)
With a DHCP network, use the VertX Discovery GUI on the
PC to locate and connect to Edge.
Note: The Edge must be connected to the network before
power is applied for DHCP to function.
1. With the PC connected to the same network as Edge,
click Start > Programs > VertX Tool Box > Discovery
GUI.
2. Select the desired device from the list
3. Click Configure Unit
If the Discovery GUI is not installed on the PC, the application
can be downloaded from
Note: Windows
®
XP is required for the Discovery GUI.
5
Configure
The web browser will prompt for login information. From the Login screen enter admin, leaving the Password field empty. Follow
the instructions on the web browser screen to configure Edge.
6
Test
Test the system once per year using the web Graphical User Interface to ensure all wiring and configuration is correct.
For additional installation information, such as PIR and other active Request-to-Exit (REX) devices, as well as connecting fire
relays, please see:
.
Battery Replacement
There are no User serviceable parts within the device. The lithium battery shall be replaced be a trained service
technician only.
Replace battery with Panasonic, Part No. CR2032 or equivalent. Use of another battery may present a risk of fire or
explosion.
CAUTION: Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire. To prevent a
risk of explosion do not pry the battery out with a metal or conductive tool.
EdgeReader and EdgePlus are the trademarks or registered trademarks of HID Global Corporation in the U.S. and other countries.
North America
15370 Barranca Parkway
Irvine, CA 92618, USA
support: [email protected]
sales: [email protected]
main: (800) 237-7769
sales: (800) 210-4744
fax number:
732-2120
Europe, Middle East & Africa
Phoenix Road
Haverhill, Suffolk CB9 7AE, England
support: [email protected]
sales: [email protected]
telephone: +44 (0) 1440 714 850
fax number: +44 (0) 1440 714 840
Asia Pacific
19/F 625 King’s Road
NorthPoint, Island East, Hong Kong
support: [email protected]
sales: [email protected]
telephone: (852) 3160 9800
fax number: (852) 3160 4809
(949)
hid
t