Figure, 5 an – HID EntryProx Installation Guide User Manual
Page 15
EntryProx™ User Guide
Part No. 4045-905, Rev C.2
9. Make the wiring connections for the Request to Exit
switch, the door locking devices, the power supply, and
the alarm inputs and outputs. Refer to WIRING, page23
for appropriate wiring instructions.
10. Reattach the main circuit board to the controller keypad
unit.
11. Insert the blank filler piece into the controller keypad
unit.
12. Attach the controller keypad unit to the mounted
backplate and secure the EntryProx unit with a hex
screw or tamper screw.
13. Run the additional antenna cable to the antenna
housing location.
14. Mount and wire the antenna housing
P4 Connector Cable
Assembly
Figure 5 Removing the P4 Connector
February 7, 2007
Page 15 of 58
© 2007 HID Global Corporation. All rights reserved.