HID EntryProx Installation Guide - Manual (Page 36)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
•
Entering a valid [99 # Master code*] sequence
•
The expiration of the keypad timer
The Invalid PIN Lockout function disables all keypad PIN entries
with the exception of the [99 # Master Code*] sequence for the
duration of the lockout.
To clear an active timed Invalid PIN Lockout do any of the
following:
•
Disconnect power to the system
•
Present a valid prox card programmed as “Card Only” or
“Card OR Code”
•
Enter the [99 # Master Code *] sequence
Note that if an invalid [99# Master Code*] is entered as part of the
sequence to clear the IPL, a subsequent good [99# Master Code*]
sequence will not cancel the current lockout.
8.3 RESETTING THE MASTER CODE AND
SYSTEM DEFAULTS ONLY
Command 40 erases everything from the EntryProx memory
except the user list and transaction log and restores the default
settings. This is useful if the EntryProx unit has experienced
programming problems, or if you wish to delete earlier
programming.
When you do this command the following rules apply:
•
If user #0 has not been programmed and user #1 is
programmed then user #0 is erased and user #1 is set to
default (1234).
•
If user #0 has been programmed and user #1 has not been
modified, user #0 and user #1 are set to default data (1234).
•
If user #0 has been programmed and user #1 has been
modified, user #0 is set to default (1234) and user #1 is not
changed.
Page 36 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.