Using the erase intensity option (dtc400e/c30e) – HID DTC400E/C30E/M30E User Guide User Manual
Page 253
Advertising
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1)
7-15
This will erase the full card. The card may be stored or printed on again.)
Using the Erase Intensity Option (DTC400e/C30e)
Step Procedure
1
This setting is used only when the None-Re-Writable ribbon option is selecting
in the driver Devise Options tab. This option takes the place of the Overlay Heat
(O) options in the driver when None RE-Writable is selected.
• Increasing this value will aide the erasing properties when using this
process repeatedly on the same card. More intensity may be needed to
fully erase these cards.
Advertising