HID FARGO HDPii User Guide - Manual (Page 148)

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
148
Accessing the Network Setup Menu
Step Procedure
1 Apply power to the Printer.
2 Ensure that the Printer is connected to your network.
3 Wait up to one (1) minute to allow the Printer to configure the IP address.
4 Select Options on the LCD.
5 Select Menu on the LCD.
6 Select the Next button on the LCD until the Network Settings menu entry
appears.
7 Press Select when Network Settings appears on the LCD.
Changing the DHCP Setting
Step Procedure
1 See the Accessing the Network Setup Menu procedure (above) to access
the Network Settings menu:
Options -> MENU -> Next -> Network Settings
2 Select Next on the LCD to view the DHCP menu entry.
• DHCP Enabled indicates that the automatic IP assignment is selected.
• DHCP Disabled indicates that the static IP assignment is selected.
3 Press the Change button to switch the DHCP setting.
4 If you change the setting, you will be prompted to reboot the Printer.
Changing the ANEG setting
The ANEG status indicates the current setting of the network configuration of the Ethernet
interface.
• This value can be set explicitly by the User to force the Ethernet interface configuration in
cases where auto negotiation fails.
• Failure of the automatic network configuration can cause slow data transmission, longer
print times or network connection problems.