Karcher FP 303 - Manual (Page 11)

– 5
Illustration

Remove the transport locks the first
time you use and before using the appli-
ance by pulling them off.
Illustration

Assemble both parts of the strut and se-
cure with the enclosed screw and nut.
 Insert the entire strut into the polishing
head and attach with a screw.
Note: Here, take into account the loca-
tion of the mains cable.
Illustration

Press the mains cable into the attach-
ments and tension it.
Illustration

Insert the straight end of the suction
hose into the polishing head, insert the
bent end into the strut connection.
Illustration

First, push the upper part of the cloth
bag into the intake until it locks.
 Then attach the bottom part to the strut
using the Velcro pad.
Illustration

Open the zipper of the cloth bag.
 Insert the filter bag and slide the carton
with the opening over the support until it
locks into place. Recheck the correct
positioning of the filter bag.
 Close the zipper on the cloth bag.
Illustration

Place the appliance on the floor so that
the polishing head is positioned perpen-
dicular to the surface.
 Simply press the pad holder into the in-
take. Ensure that the noses of the pad
holders lock well into the intake.
 To remove the pad holders, simply pull
them off.
Illustration

Install the polishing pads on the pad
holders and ensure that they are cen-
tered properly.
 To remove the polishing pads, simply
pull them off.
 The polishing pads can be stored in a
separate compartment in the bottom
part of the cloth bag.
Note:
Always work with the filter bag inserted.
ṇ
Caution
Before inserting the mains plug, ensure
that the strut is located in a vertical position.
The appliance is switched off in this posi-
tion.
Illustration

Turn the upper cable hook and remove
the mains cable. Insert the mains plug
into a socket.
Illustration

Press hold down the unlocking key. Pull
the shaft in the rear direction. The de-
vice is activated.
 To stop the appliance, bring the strut
back to the vertical position until it locks.
Remove transport lock
Assemble the strut and attach it
Connect suction hose
Inserting the cloth bag
Inserting a filter bag
Insert pad holder
Insert the polishing pads
Storing the polishing pads
Operation
11 EN