Alto-Shaam AR-7VH - Manual (Page 14)

The Alto-Shaam rotisserie provides the operator with the ability to set as many as seven cooking programs.
Each cooking program can be preset to include all cooking and holding functions. Cooking programs are
stored and recalled using the P
RESET Keys labeled 1 t h r o u g h 7 .
PROGRAMMING A COOKING PROGRAM:
With the rotisserie oven in the “
OFF ” position, determine the food product procedure to be
programmed. Press and release control ON / OFF key. The oven will beep for one second and power to
the unit will be indicated by an illuminated green indicator light located in the upper left corner of the
O
N /O FF key. The oven will begin operating in the hold mode. The amber hold indicator will be
illuminated and the last set hold temperature will be displayed.
E N T E R A L L C O O K I N G A N D H O L D I N G PA R A M E T E R S F O R T H E
P R O D U C T S E L E C T E D A S I N S T R U C T E D O N T H E P R E V I O U S PA G E .
Select a number for the programmed product. Press and hold the selected P RESET number key
until you hear an audible signal which will occur within approximately 4 seconds. The number
key program indicator light will illuminate. The programmed product is now stored in memory
on the specific number key selected. Additional programs can be stored in the remaining P RESET
Keys if not previously programmed.
TO COOK WITH PRESET MENU KEYS:
PRESS AND RELEASE CONTROL ON / OFF KEY.
• The control will beep and the green indicator light on the ON / OFF key will illuminate.
• The amber hold indicator will illuminate.
• The oven will begin operating in the hold mode.
• The previously set hold temperature will be displayed.
• The green indicator will illuminate on all programmed
PRESET Keys.
PRESS DESIRED PRESET KEY (1 THROUGH 7)
• The Pre-Heat indicator will illuminate.
➥ The rotisserie oven will automatically preheat to the cooking temperature programmed.
• The oven will beep when preheated and the preheat indicator will go out.
• Both the Ready and Start indicator lights will flash.
➥ The set cook temperature will be maintained by the oven and appear in the display
while in the ready/start mode.
LOAD THE PREPARED PRODUCT SPITS INSIDE OVEN AND CLOSE THE OVEN DOOR.
PRESS AND RELEASE START KEY.
NOTE: The rotisserie will beep 4 times when cooking is finished.
P R E S E T M E N U K E Y O P T I O N
NOTE: The last P RESET Key programmed will be the oven cooking run sequence for the next product to
be programmed. Settings can be manually changed for the next product and an alternate
pre-programmed letter key selected.
A R - 7 E R o t i s s e r i e w i t h A R - 7 V H Ve n t l e s s H o o d O p e r a t i o n & C a r e M a n u a l • 1 3
O P E R AT I N G I N S T R U C T I O N S