Arcam digital radio tuner DT81 - Manual (Page 5)

DT81
5
Additional rear panel functions
Data Service switch: DAB makes provision for providing
dedicated text and other data services in the multiplex
datastream.This switch can be set to the ‘in’ position (using the
end of a ballpoint pen) to prevent data services from appearing
among the available services on the tuner’s display.
RDI out: The Radio Data Interface (RDI) is an optical data
output that may allow future expansion to use certain data
services via an outboard device such as a personal computer.
The Data Service switch must be set to the ‘out’ position to
access the data streams from these services.
Connecting to a power supply
Wrong plug?
Check that the plug supplied with the unit fi ts your supply and
that your mains supply voltage agrees with the voltage setting
(115V or 230V) indicated on the rear panel of the unit 1 .
If your mains supply voltage or mains plug is different,
consult your Arcam dealer or Arcam Customer Support on
+44 (0)1223 203203.
Mains lead
The appliance is normally supplied with a moulded mains plug
already fi tted to the lead. If for any reason the plug needs to
be removed, it must be disposed of immediately and securely,
as it is a potential shock hazard when inserted into the mains
socket. Should you require a new mains lead, contact your
Arcam dealer.
Plugging in
Push the plug (IEC line socket) of the power cable supplied with
the unit into the POWER INLET socket 2 in the back of the unit.
Make sure it is pushed in fi rmly.
Put the plug on the other end of the cable into your power
supply socket and switch the socket on.