ALESIS Studio Interface MasterControl - Manual (Page 27)

25
8. Move to the “Drivers” tab. Click on each input pair and also on the output pair to make them
available to Sonar. The available input channels (corresponding to the MasterControl’s input
channels) will depend on the sampling rate, which you can set in the “General” tab. There will
always be three available output channels, which correspond to the three stereo pairs of physical
outputs (1/2, 3/4, and 5/6) on the MasterControl. Note that the options will always be odd-
numbered channels as each channel shown actually corresponds to a stereo pair of channels on
the MasterControl.
9. Click “OK” to close the “Audio Options” window and begin recording.
10. See the SONAR notes later in this manual for details on MasterControl operation with SONAR.