Altinex MX2456RM - Manual (Page 12)

SWITCHERS
11
7. [#Bn] - Beep ON/OFF
This command activates or deactivates the
beeping sound when a key is pressed on the
switcher module.
# = Switcher module ID number (Default is 0)
n = ON/OFF switch
n = 1, turns switcher Beep ON
n = 0, turns switcher Beep OFF
Example:
Sending the [8B1] command sets the beeper to
the ON position in the connected Switcher
module with an ID number of eight.
8. [OASn] - Auto Switch
The [OASn] command sets the switcher module
to the ON position to detect incoming audio or
video signals automatically. Using this
command, the user may also operate the
switcher manually.
n = ON/OFF switch
n = 1 (turns auto switcher ON)
n = 0 (turns auto switcher OFF)
Example:
Sending the [OAS1] command will set the auto
switch feature to the ON position to detect the
incoming video signal automatically.
9. [0I#] - Change Identification Number
This command sets a unique ID number to
each MX2456RM Switcher being used. A
maximum of 9 unit ID’s can be assigned.
0 = Zero
# = New switcher module ID number. (no. from
1 to 9)
Example:
Sending the command [0I8] will reset the active
Switcher module with a new ID number eight.
In addition, by default the switchers still have
an ID number of zero.
10. [#CA n1 n2 ] - Audio Gain Control Save
Settings
This command will save the volume settings for
a specified audio input.
# = Switch number (No. from 1 to 9, Default is 0)
n1 = Audio input number (No. from 0 to 6)
n2 = Audio Gain (Hexadecimal no. from 1 to F).
Example:
After executing the [8CA6F] command,
switcher module 8 and audio input number 6
will have a maximum volume of F (0 = OFF,
default is 8 or normal volume).
11. [#CA n1 n2 ] – Video Equalization Save
Settings
This command saves the settings of the
equalized video signal to compensate for cable
distance from the video source to the switcher.
# = Switch number (Default is 0. No. from 1 to
9).
n1 = Video input number (No. from 0 to 6).
n2 = Video equalization (Hexadecimal no. from
1 to F).
Example:
After executing the [8CA58] command,
switcher module 8 and video input number 5
will have a medium equalization range of 8 (0 =
OFF).
12. [#VR] - Firmware Version
This command displays the firmware revision
number installed into the microprocessor.
# = Switch number (No. from 1 to 9. Default is
0).