Sony WAHT-SBP2 - Manual (Page 10)

10 GB
3
Press ?/1 (Power) on the
surround amplifier.
The S-AIR/STANDBY indicator turns
green. If not, see “Checking the
transmission status” (page 10) and
“Troubleshooting” (page 12).
4
Set up the speakers.
If the S-AIR main unit has the Auto
Calibration function, perform Auto
Calibration.
If the S-AIR main unit does not have
the Auto Calibration function, perform
the appropriate speaker setting.
For details, refer to the operating
instructions of the S-AIR main unit.
Checking the
transmission status
You can check the status of sound
transmission between the S-AIR main unit
and surround amplifier by checking the
S-AIR/STANDBY indicator on the
surround amplifier.
About the standby mode
The surround amplifier enters standby mode
automatically (the S-AIR/STANDBY
indicator turns red) when the main unit is in
standby mode or wireless transmission is
deactivated.
The surround amplifier is turned on
automatically (the S-AIR/STANDBY
indicator turns green) when the system is
turned on and wireless transmission is
activated.
Note
• Depending on the main unit, the surround
amplifier may not enter standby mode
automatically or may not turn on automatically.
In this case, press ?/1 (Power) on the surround
amplifier to change the power mode.
Preventing transmission
to neighbors (Pairing)
If your neighbors also have S-AIR products
and their IDs are the same as yours, your
neighbors could receive the sound of your
S-AIR main unit. To prevent this, you can
identify your S-AIR products by performing
the pairing operation.
x Before the pairing operation
(example)
The sound transmission is established by the
ID.
S-AIR/
STANDBY
indicator Status
Turns green. The system is turned on,
wireless transmission is
activated and surround
signals are transmitting.
Flashes green
quickly. The system is turned on
and wireless transmission
is activated, but surround
signals are not
transmitting.
Flashes green
slowly. The system is turned on
and wireless transmission
is deactivated.
Turns red. The surround amplifier is
in standby mode while the
system is in standby mode
or wireless transmission is
deactivated.
Turns off. The surround amplifier is
turned off.
Flashes orange. The wireless transceiver is
not connected to the
surround amplifier.
Flashes red. The surround amplifier’s
protection is active.
S-AIR/
STANDBY
indicator Status