Aussie 8462 - Manual (Page 16)

· Wash the porcelain coated Cooking Grids (1) with a
mixture of hot water and baking soda.
· Empty the foil pan and grease tray after each cooking
session so excessive grease does not accumulate.
Failure to remove grease may result in grease
dripping onto the cart and/or a grease fire in the
tray.
· Open Hood before lighting the grill to prevent an
explosion from gas buildup.
· Always inspect the gas hose and regulator
assembly
before each use. If the hose is cut, damaged, or
shows signs of excessive abrasion or wear, do not
use the LP gas grill. Contact the manufacturer, as
the hose and regulator assembly must be
replaced with an assembly specified by the
manu facturer prior to further use of the LP gas
grill.
3) From the “Off” position, push control knob in on the left
burner and turn counter-clockwise until you feel resistance.
Pause 4 seconds, then continue turning the control knob
until a click is heard and the burner is lit.
4) Light the remaining burners by turning the control knob
counter-clockwise. Your grill has a crossover ignition system
that allows the burners to light successively off one another.
Confirm each burner is lit before lighting another burner.
5) If any of the burners do not light, repeat Step 3. The burner
should light within three or four attempts. If burner still does
not light, try the next burners from left to right.
WARNING: If any or all burners fail to light after
following Steps 3 & 4, turn all knobs to the “off”
position and close the valve on the LP gas cylinder.
Wait five minutes; then repeat all of the above lighting
procedures.
Note:If the burners still fail to light, refer to the
Troubleshooting page. The burner can be lit manually. See
Manual Lighting of the Grill.
6) After ignition, preheat the grill by turning the control to
“High” position for 3-5 minutes. The grill should be
pre-heated before every cooking session.
WARNING: If a burner goes out during the cooking
cycle, turn all knobs to the off position and close the valve
on the LP cylinder. Open hood and wait five minutes before
attempting to relight the grill.
Preparation Before Cooking
Lighting the Grill Using the Integra-
Spark Ignition System
2. Turn LP cylinder handle
counter-clockwise - “ON”
1. Open hood
3. Push in and turn control knob
counter-clockwise until you feel
resistance, wait 4 seconds then
continue until a click is heard and
the burner is lit.
How to light your LP gas grill (See diagram below
for illustrations)
1) Open Hood.
2) Important: Make sure control knobs are turned
“off” first. Open the LP gas cylinder valve by turning
the valve handle counter-clockwise until it stops.
The hood should be closed during preheating.
16