Asus A7V400-MX - Manual (Page 51)

ASUS A7V400-MX motherboard user guide 2-19
Onboard Serial Port 1 [3F8/IRQ4]
These fields allow you to set the interrupt address of the serial port. Configuration
options: [Disabled] [3F8/IRQ4] [2F8/1RQ3] [3E8/IRQ4] [2E8/IRQ3] [Auto]
Onboard Serial Port 2 [2F8/IRQ3]
These fields allow you to set the address for the onboard serial connector.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/1RQ3] [3E8/IRQ4] [2E8/IRQ3]
[Auto]
Onboard Parallel Port [378/IRQ7]
This field allows you to set the address of the onboard parallel port connector.
Configuration options: [Disabled] [378/IRQ7] [278/IRQ5] [3BC/1RQ7]
Parallel Port Mode [ECP+EPP]
This field allows you to set the parallel port operation mode. Setting to [SPP] allows
normal speed operation but in one direction only. [EPP] allows bi-directional
parallel port operation. [ECP] allows bi-directional DMA mode operation, while
[ECP+EPP] allows normal speed operation in a two-way mode.
Configuration options: [SPP] [EPP] [ECP] [ECP+EPP]
ECP Mode Use DMA [3]
This field sets the parallel port DMA channel for the selected ECP mode. The
default setting is 3. This selection is available only if you select [ECP] or
[ECP+EPP] in the Parallel Port Mode item. Configuration options: [1] [3]
EPP Mode Select [EPP1.7]
This field sets the EPP mode. The default setting is EPP1.7. This selection is
available when you set the Parallel Port Mode to [EPP] or [ECP+EPP].
Configuration options: [EPP1.9] [EPP1.7]
2.5.2 I/O Device Configuration
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [ECP+EPP]
ECP Mode Use DMA [3]
EPP Mode Select [EPP1.7]
AC97 Audio [Auto]
Onboard LAN [Enabled]
Onboard LAN Boot ROM [Disabled]
Game Port Address [201]
MIDI Port Address [Disabled]
MIDI Port IRQ 10
I/O Device Configuration
F1 : Help ↑↓ ↑↓ ↑↓ ↑↓ ↑↓ : Select Item -/+ : Change Value F5 : Setup Defaults
ESC : Exit →← →← →← →← →← : Select Menu Enter : Select Sub-menu F10 : Save and Exit
Select Menu
Item Specific Help
Set Base I/O address
for serial port 1.