Aiwa AZ-RS1 - Manual (Page 17)

17
Using the radio
Presetting radio
stations
You can preset up to 20 FM radio stations,
10 stations each for FM 1 and FM 2.
To preset stations
automatically
(Auto preset)
1
Perform steps 1 and 2 of
“Listening to the radio” (page 16)
to select the band.
2
Press PRESET.
“ ” and the preset numbers appear
in the display.
3
Press and hold PRESET for more
than 2 seconds.
“ ” starts flashing, and the player
starts scanning for stations from the
lower frequencies.
The first received station is preset on the
preset number 1, and then the player
starts scanning for the next receivable
station.
If you press Nx/POWER or TUNER
during auto presetting, the player stops
scanning and exits the auto preset mode, and
music data playback starts or the radio is
switched to the other band.
To enhance detection of
receivable stations
If there are stations that you want preset but
cannot do it automatically because their
signals are not strong enough, change the
setting of “AUTO STOP LEVEL” to
“HIGH” in order to enhance detection of
receivable stations.
1 Press MENU.
2 Press . (DOWN) or > (UP)
repeatedly to select “AUTO STOP
LEVEL.”
3 Press MENU.
4 Press . (DOWN) or > (UP) to
select “HIGH*.”
In case the same station is preset on two
or more preset numbers because its signal
is too strong, set the “AUTO STOP
LEVEL” to “LOW.”
5 Press MENU.
* The default setting at the time of purchase is
“MID.”
Note
Changing the setting of “AUTO STOP LEVEL”
does not change the reception sensitivity.
To improve the reception
The headphone cord functions as the FM
antenna. Extend the cord to improve the
reception.
PRES ET
TUNE R MEN U
(Continued)