American Audio CK-1000 MP3 - Manual (Page 13)

© American Audio ® - www.AmericanAudio.us - CK 1000Mp3 Instruction Manual Page 13
applied to a channel signal.
CHANNEL BASS CONTROL - This knob is
used to adjust the low frequency levels of a chan-
nel allowing for a maximum bass gain of +12dB
or maximum signal decrease of -30dB. Turning
the knob in a counter-clockwise direction will
decrease the amount of bass applied to a chan-
nel signal, turning the knob in a clockwise direc-
tion will increase the amount of bass applied to a
channel signal.
26. mASTER VOLUmE LEVEL INDICATORS -
The dual MASTER LEVEL LED indicators are used
to detail the master output level. The meters will
detail the output level of both the left and right
channels.
27. CHANNEL FADER - These faders are used to
control the output signal of any source assigned
to its particular channel.
28.
RELAY BUTTON - This button activates the
FLIP-FLOP™ function.
29. Q-START ON/OFF SWITCH - With this func-
tion you can use the crossfader to start and stop
the CD play. The on/oFF “Q” START switch acti-
vates the fader “Q” start feature. When the fader
“Q” start feature is activated sliding the croSS-
fadEr (30) from left to right will play or cue the
CD player connected.
Example: Be sure the Fader “Q” Start
feature is activated on both channels.
Slide the crossfader to the channel one
position (full left) and begin playback on
CD drive one. Slide the crossfader to the
channel position (far right). This will im-
mediately trigger the play function on CD
drive two and return CD drive one to cue
mode. To return to normal fader operation
turn the Fader “Q” Start on/oFF SWITCH
to the OFF position.
30. REPLACEABLE CROSSFADER - This fader
is used to blend the output signals of channels
one and two together. When the fader is in the full
left position (channel 1), the output signal of chan-
nel one will be controlled by the master volume
level. The same fundamentals will apply for chan-
nel two. Sliding the fader from one position to
another will vary the output signals of channels
one and two respectively. When the crossfader
is set in the center position, the output signals of
both the channels one and channels two will be
even.
31. CUE mIx - This knob is used send a chan-
nels incoming signal to the headphones. Turn
the knob counter-clockwise to monitor Channel
1, and clockwise to monitor Channel 2. The cue
level is adjusted by the cuE lEVEl VolumE
knoB (32). Be sure the cue level is set to mini-
mum before putting a pair of headphones on.
32. CUE LEVEL VOLUmE KNOB - This knob is
used to adjusts the headphone volume output
level. Turn the knob in a clockwise direction to
increase the headphone volume.
33. mASTER VOLUmE CONTROL - This rotary
knob is used to control the master output level
(volume). To avoid distorted output try to main-
tain an average output signal level +4 dB. Be sure
this volume control is always set to zero before
turning the unit on.
34. mICROPHONE VOLUmE - This knob is used
to regulate the microphone output volume. Turn-
ing the knob in a clockwise direction will increase
the volume level.
GENERAL FUNCTIONS AND CONTROLS (Cont.) mIxER