American Audio CK-1000 MP3 - Manual (Page 15)

trol (33).
40. RCA mASTER OUTPUTS - The Master
Output includes a pair Xlr BalancEd jackS
(37) as well as a pair of RCA Unbalanced Jacks.
The RCA jacks send a low current unbalanced
output signal. These jacks should only be used
for shorter cable runs to signal processors or
looping to another mixer. For cable runs greater
than 15 feet use the Xlr BalancEd jackS
(37).
41. LINE 1 INPUT JACKS - do not connEct
turntaBlES to tHESE jackS! CD players,
Tape Decks and other line level instruments may
be connected to these jacks. The red colored
RCA jack represents the right channel input and
the white represents the left channel input. Input
volume will be controlled by channel one fader.
The channel SourcE SElEctor SWItcH (22)
must be in the "Line 1" position, to monitor any
source connected to these jacks.
42. LINE 2 INPUT JACKS - do not connEct
turntaBlES to tHESE jackS! CD players,
Tape Decks and other line level instruments may
be connected to these jacks. The red colored
RCA jack represents the right channel input and
the white represents the left channel input. Input
volume will be controlled by channel two fader.
The channel SourcE SElEctor SWItcH (22)
must be in the "Line 2" position, to monitor any
source connected to these jacks.
43. mICROPHONE - This combo jack will accept
a standard 1/4 plug or XLR 3-pin balanced male
plug. The volume output level for this micro-
phone will be controlled by the mIc VolumE
control knoB (34).
Note: We recommend
that you use a 500-600ohm microphone for
the best sound quality.
44. POWER BUTTON - This button is used to
turn your unit’s power on and off.
45. VOLTAGE SELECTOR - Because power
supplies vary from location to location we have
incorporated a selectable voltage switch. This
switch can select a voltage input of 115v~60Hz
or 230v~50/60Hz. Always disconnect the power
plug before changing the voltage.
Dual Voltage models only
46. POWER CONNECTOR - This connection is
used to connect your main power. Be sure that
your local power matches the unit’s required
power.
NEVER REMOVE THE GROUND PRONG
FROM THE POWER CABLE, DOING SO MAY
RESULT IN IMPROPER OPERATION.
GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & BACK PANEL
© American Audio ® - www.AmericanAudio.us - CK 1000Mp3 Instruction Manual Page 15