Setup 7: adjusting the tilt and height, Setup 7: a – Sony SDM-X72 User Manual

Page 10

Advertising
background image

10

If no picture appears on your screen

• Check that the power cord and the video signal cable are

properly connected.

• If NO INPUT SIGNAL appears on the screen:

– The computer is in the power saving mode. Try pressing any

key on the keyboard or moving the mouse.

– Check that the input signal setting is correct by pressing the

INPUT button repeatedly (page 11).

• If CABLE DISCONNECTED appears on the screen:

– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by pressing the

INPUT button repeatedly (page 11).

• If OUT OF SCAN RANGE appears on the screen, reconnect

the old monitor. Then adjust the computer’s graphics board in
the following ranges.

For more information about on-screen messages, see “Trouble
symptoms and remedies” on page 20
.

No need for specific drivers

The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.

The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Setup 7: Adjusting the tilt and

height

This monitor can be adjusted within the angles and heights shown
below.

To use the monitor comfortably

Adjust the viewing angle of your monitor according to the height
of your desk and chair, and so that light is not reflected from the
screen to your eyes.

Note

When adjusting the screen tilt and height, proceed slowly and carefully,
being sure not to hit the monitor against the desk or the base of the display
stand.

SDM-X52

SDM-X72/X82

Horizontal frequency 28 – 61 kHz

28 – 92 kHz

Vertical frequency

56 – 75 Hz

56 – 85 Hz

Resolution

1024

× 768 or less 1280 × 1024 or less

30°

approx. 50°

approx. 80°

approx. 45°

(SDM-X82 only)

approx. 45°

Advertising
This manual is related to the following products: