Sony SDM-X72 - Manual (Page 13)

13
US
2 Press the M / m buttons to select 8 (BRIGHTNESS)
and press the OK button.
The BRIGHTNESS menu appears on the screen.
3 Press the M / m buttons to adjust the brightness.
SCREEN
(analog RGB signal only)
x Automatic picture quality adjustment
function
When the monitor receives an input signal, it
automatically adjusts the picture’s position and
sharpness (phase/pitch), and ensures that a clear
picture appears on the screen (page 18).
Note
While the automatic picture quality adjustment function is activated, only
the 1 (power) switch will operate.
If the automatic picture quality adjustment function of
this monitor seems to not completely adjust the
picture.
You can make further automatic adjustment of the picture quality
for the current input signal. (See AUTO below.)
If you still need to make further adjustments to the
picture quality
You can manually adjust the picture’s sharpness (phase/pitch) and
position (horizontal/vertical position).
These adjustments are stored in memory and automatically
recalled when the display receives the same input signal.
x Make further automatic adjustments to the
picture quality for the current input signal
(AUTO)
1 Press the MENU button.
The main menu appears on the screen.
2 Press the M / m buttons to select (SCREEN) and
press the OK button.
The SCREEN menu appears on the screen.
3 Press the M / m buttons to select AUTO and press the
OK button
Make the appropriate adjustments of the screen’s phase, pitch
and horizontal/vertical position for the current input signal
and store them.
4 Press the M / m buttons to select and press the OK
button.
Return to the menu screen.
x Adjust the picture’s sharpness manually
(PHASE/PITCH)
You can adjust the picture’s sharpness as follows. This
adjustment is effective when the computer is connected to the
monitor’s HD15 input connector (analog RGB).
1 Set the resolution to 1024
×
768 (SDM-X52)
1280
×
1024 (SDM-X72/X82) on the computer.
2 Load the Utility Disk.
3 Start the Utility Disk and display the test pattern.
For Windows
Click [Utility] t [Windows]/[Win Utility.exe].
For Macintosh
Click [Utility] t [Mac]/[Mac Utility].
4 Press the MENU button.
The main menu appears on the screen.
5 Press the M / m buttons to select (SCREEN) and
press the OK button.
The SCREEN menu appears on the screen.
6 Press the M / m buttons to select PHASE and press
the OK button.
The PHASE menu appears on the screen.
7 Press the M / m buttons until the horizontal stripes
are at a minimum.
Adjust so that the horizontal stripes are at a minimum.
8 Press the OK button.
The main menu appears on the screen.
If vertical stripes are observed over the entire screen, adjust
pitch by the following steps.
9 Press the M / m buttons to select (SCREEN) and
press the OK button.
The SCREEN menu appears on the screen.
10 Press the M / m buttons to select PITCH and press the
OK button.
The PITCH menu appears on the screen.
Note
When receiving digital RGB signals from the DVI-D input connector
for INPUT1, adjustment is unnecessary.
1 2 8 0 1 0 2 4 6 0 H z x /
E X I T
AU TO
P H A S E
P T C H
H C E N T E R
V C E N T E R
S C R E E N
I
(continued)