Sony STR-DN1020 - Manual (Page 10)

10 GB
D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB03DES_STR-
DN1020-CEL.fm masterpage: Left
STR-DN1020
4-273-051-14(1)
Indicators on the display panel
LH
LFE
SW RH
R C L
SB R SB SB L
SR S SL
USB ANALOG ARC HDMI COAX OPT
D.L.L. PL II x z EQ RDS CAT MEM DTS HD MSTR HI RES LBR ZONE 2 PARTY -
-
- A.P.M. D.RANGE ST SIRIUS DTS ES LPCM SLEEP BI AMP SP A B 96 24
D + EX True HD
1 2 3 4 5 9 8 7 6
qd qf qg qh qj ql qk w; wa qs qa 0
A SW
Lights up when the audio signal is output from
the SUBWOOFER jack.
B USB
Lights up when iPhone/iPod or USB device is
detected.
C D.L.L.
Lights up when the D.L.L. (Digital Legato
Linear) function is activated.
D Input indicator
Lights up to indicate the current input.
ANALOG
– No digital signal is being input.
– INPUT MODE is set to “ANALOG”.
– The “A. DIRECT” is being selected.
HDMI
The receiver recognizes the equipment
connected via an HDMI IN jack.
COAX
Digital signal is input through the COAXIAL
jack (page 85).
OPT
Digital signal is input through the OPTICAL
jack (page 85).
ARC
TV input is selected and the Audio Return
Channel (ARC) signals are detected.
E Dolby Digital Surround indicator*
Lights up the respective indicator when the
receiver is decoding the corresponding Dolby
Digital format signals.
D
D EX
D+
TrueHD Dolby Digital
Dolby Digital Surround EX
Dolby Digital Plus
Dolby TrueHD
F NEO:6
Lights up when DTS Neo:6 Cinema/Music
decoder is activated (page 65).
G DTS-HD indicator*
Lights up the respective indicator when the
receiver is decoding the corresponding DTS-HD
format signals.
DTS-HD MSTR
DTS-HD HI RES
DTS-HD LBR
DTS-HD Master Audio
DTS-HD High Resolution
Audio
DTS-HD Low Bit Rate
Audio
H PARTY
Lights up when PARTY STREAMING function
is activated (page 77).
I ZONE 2
Lights up while operation in zone 2 is being
enabled.
J SP A/SP B/SP A B (page 38)
K BI-AMP
Lights up when surround back speakers
selection is set to “BI-AMP” (page 88).
L SLEEP
Lights up when the Sleep Timer is activated.
M LPCM
Lights up when the receiver is decoding the
Linear PCM signals.
N DTS(-ES) indicator*
Lights up the respective indicator when the
receiver is decoding the corresponding DTS
format signals.
DTS
DTS-ES
DTS 96/24
DTS
DTS-ES
DTS 96 kHz/24 bit