Sony STR-DN1020 - Manual (Page 100)

100 GB
D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB05ENJ_STR-
DN1020-CEL.fm masterpage: Left
STR-DN1020
4-273-051-14(1)
x PARTY STREAMING
You can set the receiver to use the PARTY
STREAMING function.
1 Select “PARTY STREAMING”, then
press .
2 Select “On” or “Off”, then press .
• On: The receiver can be detected by
other devices on the home network.
The receiver can start or close a PARTY,
and can join or leave a PARTY.
• Off: The receiver can be detected by
other devices on the home network.
However, the receiver cannot start or
close a PARTY, and cannot join or leave
a PARTY.
x Access Settings
You can set access restriction or permission for
the devices on the device list.
To set the auto access
permission
1 Select “Access Settings”, then press
.
2 Select “Auto Access”, then press .
3 Select “Allow” or “Not Allow”, then
press .
• Allow: All the devices on the home
network are permitted to access this
receiver.
This receiver can start a PARTY as host
device and join a PARTY as a guest
device if requested.
• Not Allow: The receiver restricts a new
device that is accessing the receiver.
When connecting a new device to the
home network, add the device to the
device list, and set access permission
(page 100).
Note
Up to 20 devices can be added to the device list. If
20 devices have already been registered, “Device
Full” appears, and a new device cannot be added to
the list. In this case, delete unnecessary devices from
the list (page 100).
To add devices to the device list
1 Select “Access Settings”, then press
.
2 Select “Control Device”, then press .
The device list appears on the TV screen.
3 Select “Add Device”, then press .
4 Select the device you want, then press
.
The selected device is added to the device
list. For details on setting the access
permission, see “To set access permission
for the devices” (page 100).
To set access permission for
the devices
You can set access permission for a device on
the device list. Only devices set to “Allow” are
recognized on the home network.
1 Select “Access Settings”, then press
.
2 Select “Control Device”, then press .
The registered device list appears on the
TV screen.
3 Select the device you want, then press
.
4 Select “Access”, then press .
5 Select “Allow” or “Not Allow”, then
press .
To delete a device from the list
Select “Delete” in step 4, then press . Select
“OK” on the confirmation display, then press .
x Media Remote Device
Registration
Lets you register your Media Remote devices.
To register the Media Remote
devices
1 Select “Media Remote Device
Registration”, then press
.