Trouble check – Sony CCD-TRV211 User Manual

Page 44

Advertising
background image

44

CCD-TRV11/TRV19/TRV21/TRV29/TRV119/TRV211 3-810-780-23.E

Symptom

The date or time indicator
disappears.

Recording stops in a few
seconds.

Picture

Symptom

The image on the viewfinder
screen is not clear.

A vertical band appears when a
subject such as lights or a candle
flame is shot against a dark
background.

The picture is “noisy”.

The picture does not appear in
the viewfinder.

The picture does not appear on
the LCD screen.

A vertical band appears when
shooting a very bright subject.

An unknown picture is
displayed.

Others

Symptom

The supplied Remote Commander
does not work .

There is dust in the viewfinder

.

Bubbles appear inside the lens.

Cause and/or Corrective Actions

• Reset the date and time. (p. 33)

• START/STOP MODE switch is set to

or 5 SEC.

m

Set it to

. (p. 25)

Cause and/or Corrective Actions

• The viewfinder lens is not adjusted.

m

Adjust the viewfinder lens. (p. 10)

• The contrast between the subject and background is

too high. The camcorder is not malfunctioning.
m

Change locations.

• The video heads may be dirty.

m

Clean the heads using the Sony V8-25CLH cleaning

cassette. (p. 38)

• The LCD panel is open.

m

Close the LCD panel. (p. 12)

• Incorporated fluorescent tube is worn out.

m

Please contact your nearest Sony dealer.

• The camcorder is not malfunctioning.

• The camcorder operates in Demo mode.

m Exit the Demo mode. (p. 53)

Cause and/or Corrective Actions

• COMMANDER is set to OFF.

m

Set it to ON. (p. 28)

• Something is blocking the infrared rays.

m

Remove the obstacle.

• The battery is not inserted with the correct polarity.

m

Insert the battery with the correct polarity. (p. 52)

• The batteries are dead.

m

Insert new ones. (p. 52)

• Detach the eyecup and clean the viewfinder lens. (p. 39)

• When you use the camcorder where the air pressure is low

such as on a mountain or in an airplane, you may find
bubbles inside the lens. This is not a malfunction. Bubbles will
usually disappear after about a week. But, how long it takes
depends on the air pressure and use.

Trouble check

Advertising
This manual is related to the following products: