Music – Sony DR-BTN200 User Manual
Page 80
Music
No sound
Check that both the headset and the BLUETOOTH device are turned on.
An A2DP BLUETOOTH connection is not made between the headset and the
BLUETOOTH device. Make an A2DP BLUETOOTH connection.
Check that music is being played back by the BLUETOOTH device.
Check that the volume of the headset is not set too low.
Turn up the volume on the connected device if necessary.
Pair the headset and the BLUETOOTH device again.
Low sound level
Turn up the volume of the headset.
Turn up the volume on the connected device if necessary.
Low sound quality
Switch the BLUETOOTH connection to A2DP (Advanced Audio Distribution
Profile) when HFP (Hands-free Profile) or HSP (Headset Profile) is set.
If you have previously connected this BLUETOOTH device, only an HFP/HSP
BLUETOOTH connection may be made when the headset is turned on. If this
happens, select an A2DP BLUETOOTH connection.
Sound skips frequently during playback.
Reception condition of the headset may have become unstable due to
improper matching of the bit rate setting for the music transmitted from the
BLUETOOTH device and the environment in which the headset is used.*
Turn off the headset once, then turn it on again by pressing the POWER
button for about 2 seconds while pressing the VOL– button to lower the setting
Search
80
Search