Sony DCR-DVD405 - Manual (Page 22)

22
5
The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack on your camcorder.
• Disconnect the AC Adaptor holding both
your camcorder and the DC plug.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
• When you remove the battery pack, make sure
that none of the respective lamps of the POWER
switch (p.24) is on.
When storing the battery pack
Use up the battery pack completely if you do
not intend to use it for a long time (p.133).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Charging time (full charge)
Approximate time (min.) required when you
fully charge a fully discharged battery pack.
Recording time
Approximate time (min.) available when you
use a fully charged battery pack.
* Typical recording time shows the time when you
repeat recording start/stop, turning the power on/
off and zooming.
• Times shown vary according to the following
conditions.
– Top: When the LCD backlight turns on.
– Middle: When the LCD backlight turns off.
– Bottom: Recording time when recording with
the viewfinder while the LCD panel is closed.
Playback time
Approximate time (min.) available when you
use a fully charged battery pack.
* When the LCD backlight turns on.
Battery pack Charging time
NP-FP50 125
NP-FP60 (supplied) 135
NP-FP70 155
NP-FP71 170
NP-FP90 220
BATT (battery)
release lever
Battery pack
Continuous
recording
time Typical
recording
time*
NP-FP50
0 50
0 55
0 60
0 25
0 30
0 30
NP-FP60
(supplied)
0 85
0 90
0 95
0 40
0 45
0 50
NP-FP70
120
125
135 0 60
0 65
0 70
NP-FP71
145
155
160 0 70
0 75
0 80
NP-FP90
220
235
245 110
120
125
Battery pack
LCD screen
opened* LCD screen
closed
NP-FP50 0 90 110
NP-FP60
(supplied)
110 120
NP-FP70 200 235
NP-FP71 235 280
NP-FP90 345 415
Step 2: Charging the battery pack (continued)