Sony SLV-M11HF - Manual (Page 41)

41
SmartFile Function
Recording using the SmartFile
function
To use the SmartFile function, attach the SmartFile label to the spine of the
cassette tape. If you record a program on a tape with a SmartFile label,
program data, such as the date and channel, is automatically stored in the
memory of the SmartFile label.
Attaching the SmartFile label to
the cassette tape
To use the SmartFile function, attach the
supplied SmartFile label to the cassette tape.
Remove any stains or dirt from the surface of
the spine of the tape. Then, holding both
edges of the SmartFile label so that it doesn’t
bend, attach it along the guide line to the spine
of the cassette tape. This tape is henceforth
referred to as a SmartFile tape.
Note on the purchase of SmartFile labels
• For the customers in the USA
To order additional SmartFile labels, see the back page.
• For the customers in Canada
Additional SmartFile labels can be purchased at Sony of Canada Ltd. Authorized
VHS Dealers.
Notes
• The SmartFile label is equipped with a memory chip. The memory chip may be
damaged and cannot be used when you:
– twist or fold the SmartFile label.
– remove the SmartFile label and re-attach it to a tape.
– attach more than one SmartFile label to a tape.
– attach some metal, or sticker which has metal, to the SmartFile label.
– write too strongly on the SmartFile label using a ballpoint pen or similar sharp
instrument.
– disassemble or remodel a label.
• Do not leave the SmartFile label in a place subject to excessive dust or dirt, direct
sunlight, humidity, mildew, strong magnetism, or near heat sources.
• If you attach the SmartFile label to a short length tape, such as T-30 or shorter, you
cannot use the SmartFile function.
SMARTFILE SENSOR
continued