Sony DSC-T1 User Manual
Page 89
89
Tr
ou
bl
e
s
hoo
ting
Shooting still images/movies
The battery remaining
indicator is incorrect, or
sufficient battery
remaining indicator is
displayed but the power
runs out soon.
• You have used the camera for a long time in an
extremely hot or an extremely cold location.
• A deviation has occurred in the remaining
battery time.
• The battery pack is discharged.
• The battery pack is dead (page 111).
p See page 111.
p Fully discharge and then charge the battery pack so that the
battery remaining indicator functions correctly (page 13).
p Install a charged battery pack (page 11).
p Replace the battery pack with a new one.
The battery pack runs
down too quickly.
• You are shooting/viewing images in an
extremely cold location.
• The battery terminal is dirty.
• The battery pack is dead (page 111).
—
p Clean the battery terminal with a cotton swab, etc., and charge
the battery pack.
p Replace the battery pack with a new one.
You cannot turn on the
camera.
• The battery pack is not installed correctly.
• The AC Adaptor is disconnected.
• The AC Adaptor has malfunctioned.
• The battery pack is discharged.
• The battery pack is dead (page 111).
• The camera is not properly installed to the USB
cradle.
p Install the battery pack correctly (page 11).
p Properly connect the AC Adaptor (page 15).
p Consult your Sony dealer or local authorized Sony service
facility.
p Install a charged battery pack (page 11).
p Replace the battery pack with a new one.
p Properly install the camera (page 10).
The power turns off
suddenly.
• If you do not operate the camera for about three
minutes when using a battery pack, the camera
turns off automatically to prevent wearing down
the battery (page 16).
• The battery pack is discharged.
• The camera is not properly installed to the USB
cradle.
p Turn on the camera again (page 16) or use the AC Adaptor
p Install a charged battery pack (page 11).
p Properly install the camera (page 10).
Symptom
Cause
Solution
The LCD screen is not
turned on even when the
power is turned on.
• The LCD backlight is turned off with
in the
dark place.
p Turn on the LCD backlight with
The subject is not visible
on the LCD screen.
• The mode switch is not set to
or
.
p Set it to
or
Symptom
Cause
Solution