Sony NWZ-B133FBLU - Manual (Page 8)

NWZ-B133 / B135 / B133F / B135F. GB. 3-877-773-12(1)
14 15
NWZ-B133 / B135 / B133F / B135F. GB. 3-877-773-12(1)
Before Connecting the Player
Before connecting the player to your computer, make sure that the OS is Windows XP
(Service Pack 2 or later) or Windows Vista (Service Pack 1), and the installed Windows
Media Player version on your computer is 11.
Charging the Battery
The player’s battery is recharged while the player is connected to a running computer.
Remove the USB cap and connect the USB connector to a USB port on your computer.
USB connector
To
When the remaining battery indication of the display shows: , charging is complete.
When you use the player for the first time, or if you have not used the player for a long
time, recharge it fully until appears on the screen. For details on charging time or
battery life, see  page 69.
Basic Operations
Note
• Be careful not to accidentally bump or put stress on the player when it is connected to your computer.
It may be damaged.
On the remaining battery indication
The battery icon *1 in the display ( page 22) changes as shown below. See  page 69 for
details on battery duration.
* 1 If the “USB Bus Powered” setting is set to “Low-Power 100mA” ( page 45), appears next to the
battery icon.
The battery power decreases as shown by the battery icon. If “LOW BATTERY” appears,
you cannot operate the player. In this case, charge the battery by connecting to your
computer.
Notes
• Charge the battery in an ambient temperature of between 5 ºC to 35 ºC (41°F to 95°F).
• The number of times the battery can be recharged before it is used up is approximately 500 times.
This number differs, depending on the conditions under which you use the player.
• The battery indicator on the display is only an estimate. For example, one section of black in the
indicator will not always indicate exactly one-fourth of the battery’s charge.
• “DATA ACCESS” appears in the display while the player accesses the computer. Do not disconnect
the player while “DATA ACCESS” appears or the file being transferred may be destroyed.
• The control buttons on the player are all disabled while it is connected to a computer.
• Some USB devices connected to the computer may interfere with the proper operation of the player.
• We do not guarantee the recharge of the battery using personally assembled computers or modified
computers.
• If you charge the player when it has not been used for a long period, your computer may not
recognize the player or nothing may appear on the display. Charge the player for about 5 minutes, and
it starts operating properly.
Basic O
per
ations
Continued 