Sony MZ-RH1 - Manual (Page 10)

How to use the supplied ferrite core
This recorder comes with ferrite cores for
connection to the supplied remote, the
optional stereo microphone and the optional
line cable. (You must attach the ferrite
cores to comply with the applicable EMC
standards.) Be sure to connect them when
using the recorder with a computer. If not,
there is no need to connect them.
1 Open the ferrite core.
ESD-SR-110 for the optional
stereo microphone and the
optional line cable
2017-0930 for the optional
line cable
For the MZ-RH1 North American and Latin
American models:
ESD-SR-110 for the supplied
remote and the optional stereo
microphone
For the European, Asian and Chilean models:
For the MZ-M200 North American model:
ESD-SR-110 for the optional
line cable
2 Wind the cord around the ferrite cores as
follows.
For the European, Asian and Chilean
models:
• For the supplied remote control: Wind the
cord around the ferrite core once/ Approx.
4 cm (1.6 in.) from the plug
• For the optional stereo microphone: Wind
the cord around the ferrite core twice/
Approx. 1 cm (0.6 in.) from the plug
• For the optional line cable: Wind the cord
around the ferrite core once/ Approx. 1
cm (0.6 in.) from the plug
For the MZ-RH1 North American and
Latin American models:
• For the optional stereo microphone: Wind
the cord around the ferrite core twice/
Approx. 1 cm (0.6 in.) from the plug
• For the optional line cable: Pass the cord
through the ferrite core/ Approx. 1 cm
(0.6 in.) from the plug
For the MZ-M200 North American model:
• For the optional line cable: Pass the cord
through the ferrite core/ Approx. 1 cm
(0.6 in.) from the plug
Refer to step 2 for the
distance from the plug
connected to the recorder.
3 Close the ferrite core. Make sure the
clasps are fully engaged.
To attach the clip in the opposite direction
1 Remove the clip.
2 Attach the clip in the opposite direction.
10
MZ-RH1/MZ-M200.GB.2-669-084-11(1)