Sony NEX-VG30H - Manual (Page 31)

1
Table of C
on
ten
ts
Sear
ch image
Inde
x
US
You can check the recordable time, estimated remaining capacity, etc., by touching (MENU) 
[Setup]  [ ( Media Settings)]  [Media Info] (p. 81).
The LCD screen of your camcorder can display recording images across the entire screen (full pixel
display). However, this may cause slight trimming of the top, bottom, right and left edges of images when
played back on a TV which is not compatible with full pixel display. In this case, set [Guide Frame] to
[On] (p. 76), and record images using the outer frame displayed on the screen as a guide.
Data code during recording
The recording date, time and condition are recorded automatically on the memory card. They
are not displayed during recording. However, you can check them as [Data Code] during
playback. To display them, touch (MENU)  [Setup]  [ ( Playback Settings)]
 [Data Code]  a desired setting  .
Shooting photos
When disappears, the photo is recorded.

Press MODE to turn on the (Photo) lamp.
The LCD screen display switches for photo recording mode.

Press PHOTO lightly to adjust the focus, then press it fully.
Focus indicator
The focus indicator shows the focusing status by lighting/flashing.
 lit
: Focus locked.
 flashing : The camcorder cannot focus on the subject automatically. Either recompose
the shot or change the focus setting.
Tips
See page 97 on the recordable number of photos.




MODE button
PHOTO
button
(Movie): When recording a movie
(Photo): When recording a photo
Flashes  Lights up