Sony MZ-N510CK - Manual (Page 31)

31
Adjusting the sound quality
You can change the preset sound quality
and store the results in “SOUND1” or
“SOUND2”.
1
While playing, press MENU.
2
Press . or > repeatedly until
“SOUND” appears in the display, and
then press ENTER.
3
Press . or > repeatedly until
“SET” appears in the display, and
then press ENTER.
4
Press . or > repeatedly to
select “SOUND1” or “SOUND2”,
and then press ENTER.
The display shows the currently
selected “BASS” sound setting.
5
Press . or > repeatedly to
adjust the sound level.
6
Press ENTER.
“BASS” is set and the display
changes to “TRE” (treble) setting
mode.
7
Press . or > repeatedly to
adjust the sound level, and then press
ENTER.
“TRE” (treble) is set.
The sound settings are saved and the
playback display appears again.
To cancel selecting
Press CANCEL.
z
• Settings can also be changed while playback
is momentarily paused (X).
• If the recorder is not operated approximately
for 3 minutes, the current setting is stored and
the display automatically switches to normal
playback.
Notes
• When you use the Digital Sound Preset, the
sound may break or become distorted
depending on the settings or the track. In this
case, change the settings of the sound quality.
• Changing to another Digital Sound Preset
during a recording operation will not affect
the quality of recorded sound.
Shows “SOUND1” or “SOUND2” is
selected
The sound can be adjusted in 8 steps
(–4, –3, ...±0, ...+2, +3).