Sony CHC-CL1 - Manual (Page 7)

7
Getting Started
AM loop antenna
Extend the FM lead antenna
horizontally
Jack type B
FM75
COAXIAL
AM
3 For models with a voltage selector, set
VOLTAGE SELECTOR to the local
power line voltage.
VOLTAGE SELECTOR
230-
240V
220V
120V
4 Connect the power cord to a wall outlet.
The demonstration appears in the display.
If the plug of the power cord does not fit
your wall outlet, attach the supplied adapter
on to the plug (for models with a plug
adapter). To turn on the system, press ?/1.
The demonstration mode
The demonstration mode appears in the display
when you connect the power cord to a wall
outlet. When you press ?/1, the system turns
on and the demonstration automatically ends.
The demonstration is deactivated when you set
the time.
To activate/deactivate the demonstration again,
press DISPLAY while the system is off.
To adjust the brightness of the
display back light
1 Press DIMMER while the system is on.
2 Turn ./> (or press . or > on
the remote) to adjust the back light
brightness.
You can adjust the back light brightness in
11 steps from –5 to +5.
When carrying this system
Perform the following procedure to protect the
CD mechanism.
1 Make sure that all discs are removed from
the system.
2
Press FUNCTION while holding down CD 1
until “LOCK” appears.
3 Unplug the power cord.
Inserting two R6 (size AA)
batteries into the remote
E
e
e
E
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.