Sony MHC-MG310AV - Manual (Page 33)

Additional Information
33
The sound from the connected source is
distorted when VIDEO function is selected.
• Select MD function. If “VIDEO” appears in the
display when you press 5.1CH/VIDEO (MD)
(for MHC-MG510AV/MG310AV) or VIDEO
(MD) (for MHC-MG110 or on the remote),
switch the function to MD (see “Hooking up the
optional A/V components” on page 28).
“- - : - -” flashes in the display.
• A power interruption occurred. Set the clock and
timer settings again.
The timer does not function.
• Set the clock correctly.
“DAILY”, and “REC” do not appear when you
press TIMER SELECT.
• Set the timer correctly.
• Set the clock.
The remote does not function.
• There is an obstacle between the remote and the
system.
• The remote is not pointing in the direction of the
system’s sensor.
• The batteries have run down. Replace the
batteries.
The color irregularity on a TV screen persists.
• Turn off the TV set once, then turn it on after 15
to 30 minutes. If the color irregularity still
persists, place the speakers farther away from the
TV set.
Speakers
Sound comes from one channel or unbalanced
left and right volume.
• Connect the speaker cords properly (see page 8).
• Place the speakers as symmetrically as possible.
• Connect only one of the supplied speakers to
each set of speaker terminals.
• Connect the supplied speakers.
The sound comes from the center speaker only
(for MHC-MG510AV/MG310AV only).
• The source being played back is monaural. Press
PRO LOGIC to turn off the Dolby Pro Logic
mode.
There is no sound from the center speaker (for
MHC-MG510AV/MG310AV only).
• Connect the speaker cords properly (see page 8).
There is no sound from the rear speakers (for
MHC-MG510AV/MG310AV only).
• Connect the speaker cords properly (see page 8).
Sound lacks bass.
• Check that the speaker’s + and – jacks are
connected correctly.
CD Player
The CD will not play.
• Close the front cover.
• Check if the CD is correctly loaded in the slot.
• The CD is dirty.
• The CD is loaded with the label side facing left.
• There is moisture on the CD.
Play does not start from the first track.
• The player is in Program or Shuffle Play mode.
Press PLAY MODE repeatedly until “PGM” or
“SHUF” disappears.
The sound skips.
• The CD is dirty.
• Replace the CD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the system,
or placing them on separate stands.
• When you listen to a track with bass sounds at
high volume, the speaker vibration may cause the
sound to skip.
“OVER” is displayed.
• You have reached the end of the CD.
continued