Sony MHC-MG310AV - Manual (Page 15)

CD
15
Programing CD tracks
— Program Play
You can make a program of up to 25 tracks
from all the CDs in the order you want to play
them.
1
Press CD to switch the function to CD.
2
Press PLAY MODE repeatedly until
“PGM” appears.
3
Turn DISC ACCESS (or press T DISC
or DISC t on the remote) to select a
CD.
To program all the tracks on a CD at once,
go to step 5 with “CDAL” displayed.
4
Press – . or > + (or . or >
on the remote) repeatedly until the
desired track appears.
Disc number
Track number Playing time of
selected track
5
Press ENTER.
The track is programed. The programed
track and corresponding step (playing order)
appear.
6
Program additional discs or tracks.
To program Repeat steps
Other discs 3 and 5
Other tracks on the
same disc 4 and 5
Other tracks on other
discs 3 to 5
7
Press n N (or N on the remote).
Press PLAY MODE repeatedly
until “PGM” disappears.
Press – . or > + (or . or
> on the remote) repeatedly
during Program Play.
Other Operations
To Do this
Press CLEAR in stop mode.
Press and hold CLEAR.
Perform steps 3 to 5.
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press CD,
then press n N (or N on the remote) in
Program Play mode.
• “--.--” appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over.
• The programed disc and track numbers remain until
you erase them, so that the system plays only the
existing disc and track numbers if you replace discs.
However, the disc and track numbers that are not
found in the system or on the disc are deleted from
the program, and the rest of the program is played
in the programed order.
Cancel Program
play
Check the
program
Clear a track or
disc from the end
Clear the entire
program
Add tracks or
discs to the
program in stop
mode